![]() Test dryer temperatures and wash test printed product before and during a production run. Always check for possible dye migration when printing fabrics that contain polyester fibers. Always test print fabric before beginning a production run. The optimum time/temperature cycle will vary with the amount of ink deposited, fabric and the type of heat source used. The properly cured flock print should be vacuumed to remove excess flock fibers that have not attached themselves to the flock adhesive.Immediately after printing the 1820 Flock Adhesive, apply the flock fibers to the wet adhesive using the proper electrostatic flocking equipment.Make sure that the 1820 Flock Adhesive is kept more on the surface of the fabric when printing in order to help insure a maximum adhesive surface for the flock fibers to bond to.Stir or mix the 1820 Flock Adhesive before each use.Over catalyzation will shorten pot life of ink. Do not mix more ink than is needed for a job. Ink may be used immediately after mixing. containers and should be thoroughly hand stirred into the ink to the following proportions:Ģ0 parts ink to 1 part catalyst (5% by weight) ![]() ![]() FLOCK APPLICATIONĪXEON™ Flock Adhesive 1820 must be mixed with the 900 Catalyst before printing. Failure to fuse ink properly may cause cracking, poor adhesion and poor wash fastness. Final fusing or curing will occur in the dryer. Totally fusing the underprint may cause inter-coat adhesion problems with the inks printed on top. The ink should be dry just to the touch, with no lift off, but not totally fused. When you spot dry, you are only partially fusing or gelling the surface of the ink. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. Dwell time is dependent on the spot dryer used. This product will spot dry, with a very low after flash tack. AXEON™ Flock Adhesive 1820 is a two-part flock adhesive used to produce high quality flock prints.įlock Adhesive 1820 provides excellent adhesion to most flock fibers and produces a very soft and flexible flock print when the product is properly printed and cured.ĭesigns made with Flock Adhesive 1820 may be applied to light or dark fabrics. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |